Sealed holders which prevent the leak of the sample, easy to use.

Fast identification of microorganism.

Allows cells detection even in low concentrated liquids.

Processing time <15 min.

Alarm to prevent the drying of the samples every 20 seconds.

Available rotors for tubes (check Digicen 21 accessories).

LCD screen:

• Shows RPM and RCF, time and acceleration/deceleration (PCBS).
• Speed programming in 10 RPM/ 10 xg steps.
• Timer countdown/up from “0” or at “set RPM/ RCF” for reproducible tests.
• Timer from 1 to 99 min. programmable in 5 sec. steps and hold position.
• PCBS: Progressive controlled acceleration and braking system up to 175 selectable ramps that prevents sample homogenization after separation.
• 16 programmable memories.
• Several acoustic and visual messages warning the user the device situation.

• Microprocessor controlled.
• Induction motor maintenance free (brushless).
• Rotors list on memory.
• Noise level: below 60 dB.
• Start, stop, open lid and short spin with adjustable speed buttons.
• Option of free/locked adjustment of RPM/ RCF along the run.
• Automatic open lid, programable.
• Last values remain in memory.
• Low heigh for easy access.
• Automatic rotor recognition. Over-speed protection.

• Lid provided with security systems:
  – Automatic lid lock system, motorized with double lock.
  – Emergency lid-lock release.
  – Locking and protection against opening along the run.
  – Lid dropping protection.
  – Port in the lid for calibration and operation checking.

• Ergonomic design that allows close the lid effortless.
• Unbalance detection and switch off.
• Protection safety ring between the centrifugation chamber and the housing.
• Chamber of centrifugation in stainless steel (easy cleaning).
• Rotors and adapters autoclavable, easy to install by the user.
• Forced ventilation to reduce temperature increasing.
• Automatic disconnection for energy saving up to 8 h., with deactivation option.

EU Directives: 2011/65/EU, 2012/19/EU, 2014/30/EU, 2014/35/EU.
Standards: EN 61010-1, EN 61010-2-020, EN 61010-2-101, EN 61326-2-6,  EN 61326-1.